Hitachi Engineering & Services Co.,Ltd. : Internal Diagnosis Services with X-Ray Imaging Processor

Please find below frequently asked questions.

1.How thick can the X-ray imaging pass through the target?

Approx. 50mm ( in terms of iron )
Approx. 150mm ( in terms of aluminium)

2.How much is the diagnosis with the X-Ray imaging processor?

Depends on a subject and site conditions
Basically, the diagnosis at site is approx. ¥200,000/day, and the diagnosis at our factory is approx. ¥100,000/day

3.Is there any area restriction on the diagnosis with the X-Ray Image Processor?

No area restriction except dangerous places limited by export regulations
Basically both the X-ray generator and its operator are requested to be made
available on customer side in case of overseas in view of each county’s regulations.

4.Are there any points to which attention is to be payed?

Need to keep out during the X-Ray irradiation

5.Is it possible to take X-Ray images while the equipment is in service?

Yes. Additionally, possible to take dynamic images of the moving parts up to approx. 40 mm thick in terms of iron.

6.Are there any influences to equipment if X-ray is applied to it?

In case X-ray is radiated for 5 miniutes at once, it shall be repeated at least approx. 10⁹ times to exceed the safety limit of a variety of materials. Therefore we consider no influences to the equipment.

7.Are there any influences to human body if X-ray is applied to it?

Yes, X-ray is one of radioactive rays which seriously injure human body if it is exposed to. However, our supervisor carries out X-ray irrigation strictly observing the X-ray regulations, and hence, you are free from such dangers.

8.Where is the contact point for the X-ray diagnosis?

Please contact to our branch or HP freely

Internal Diagnosis with X-ray Imaging Processor FAQ's